Description 802.11AC Industrial Grade Wireless Bridge. IP67 Rated Connect any 2 locations wirelessly up to 1/2 mile away. Pre-Configured for Plug-n-Play installation. Wirelessly extend your network by simply connecting point A to point B using this pre-paired 802.11AC industrial PTP wireless bridge. Each Bridge-in-a-Box comes with two wireless radio modules and power supplies that can be used to extend your network from wherever you have an Ethernet port to wherever you need one from 50 feet to 1/2 mile away. The modules are extremely easy to deploy as they come pre-configured and pre-paired to connect. 19dBi Integrated Antenna inside the UHD Pro, are completely sealed. Cat5/Cat6 cable is fed through weather-tight sealed grommet for maximum protection. 128-bit AES with Traffic Prioritzation using QoS and WEP. Popular Features: 5 GHz radio with 20/40/80 MHz channel width Extend Internet Connectivity Up to 600Mbps with low latency WLAN connectivity Industrial Grade Radios 80 MHz channel width support at 802.11ac connectivity Small form factor (Antennas are 11×11″ ) Pre-Configured for out of the box “plug-n-play” installation 28 dBm Transmit Power cnMaestro Cloud Management USA Technical Support included What’s included in this 600 Mbps Wireless Ethernet bridge (complete link): 2x Outdoor 5 GHz 802.11AC Bridge Antennas 2x Gigabit Power over Ethernet Injector (POE: 15W-30V) 2x 50ft. Shielded cat5e Ethernet Cable 2x Pole Mount Hardware for 1-2″ OD mast This 802.11AC industrial PTP wireless bridge is pre-configured and paired to each other, for “out of the box” installation and operation. Operating at 5 GHz gives you an interference free wireless communication between any 2 buildings, that are less than 1/2 mile distance, and have clear, unobstructed LOS (Line of Sight). External Signal LED’s will assist with alignment and troubleshooting procedures. Maximum cat5e cable to be used on each end is 250ft. (Shielded cat5e is recommended). 1 year warranty includes USA technical support from GNS Wireless. This complete 802.11AC industrial PTP wireless bridge package requires no external software. Unifi software not required. This is a great replacement to any Trendnet, Ubiquiti or Engenius residential grade solution, plug-n-play solution that is not currently working. Higher power, zero interference, and out of the box installation.
